HomebrewGr

Build your own Xbox 360 DVD Drive Adapter

Here is a diagram for an Xbox 360 DVD Drive adapter. This is potentially similar to what Team Xecuter are making, but this one is all open source. (Thanks to Devo-E for making the adapter look very easy to build!).

The Diagram:

Adapter Pin Out
(X) ( 8 ) (6) (4) (2) (0)
(X) (9) (7) (5) (3) (1)
The X points are Dead Pins.

Full Parts List:

  • Capacitors - .o1 micro Farads (symbol looks like .01 uF) [any small value should work, it is just used to filter AC out of the line so a “true earth” ground is achieved]
  • Voltage regulator- 1086V33
  • Small wire anything around the 20-22 gauge should work
  • A small PC board
  • Some small headshrink might come in handy.
  • You will need a power connector from a original xbox, or you can make your own. The connector pin spacing on the power connector is 2mm.

Full Post

Related topics:

Performance boost for X800 GT cards with R480 GPU

N64 Overclocking Guide

Super Mario 64 comes on... PC

Increase the speed of the internet in Linux Mint

Watch TV Shows And Movies Online From Your PS4