Here is a diagram for an Xbox 360 DVD Drive adapter. This is potentially similar to what Team Xecuter are making, but this one is all open source. (Thanks to Devo-E for making the adapter look very easy to build!).
The Diagram:
Adapter Pin Out
(X) ( 8 ) (6) (4) (2) (0)
(X) (9) (7) (5) (3) (1)
The X points are Dead Pins.
Full Parts List:
- Capacitors - .o1 micro Farads (symbol looks like .01 uF) [any small value should work, it is just used to filter AC out of the line so a “true earth” ground is achieved]
- Voltage regulator- 1086V33
- Small wire anything around the 20-22 gauge should work
- A small PC board
- Some small headshrink might come in handy.
- You will need a power connector from a original xbox, or you can make your own. The connector pin spacing on the power connector is 2mm.
Read more
Published on
Read more
Published on
Read more
Published on
Read more
Published on